With the domestic production level to speed up the pace of technological transformation, so automatic screw machine also began to enter a large number of domestic market, with the domestic production technology continues to improve and mature, fully automatic screw machine prices will gradually decline. So the automatic screw machine market is now gradually optimistic about the business  This is mainly because it is on the one hand its technical requirements are relatively high, before most of the products are mainly from the United States, Germany, Japan, the introduction of the country. And now with the improvement of domestic production technology, such as Jinan, Shenzhen, Guangzhou and other places have launched a number of domestic automatic screw machine products.

In the automatic lock screw machine work, generally there are only two ways to use: respectively, air blowing and air suction in two ways, but most buyers do not quite understand where the difference between the two? How should I choose? Here to give you a specific explanation if the distinction:

Automatic lock screw machine suction:

1, air suction automatic screw machine is generally suitable for the relatively small length, light weight, air blowing automatic screw machine can not be achieved by the screw, while the head of the head and electric screwdriver vacuum suction nozzle cavity to form a certain air tightness The Suitable for most screws, especially those that do not meet the aspect ratio requirements of the screws can be used.

2, air suction automatic screw machine structure is relatively simple, relatively short manufacturing cycle. Its main features: If the screws are too small or too short, air-blown automatic lock screw machine can not automatically send nails, the need for this machine, the robot to drive the electric screwdriver screw and move the lock (one by one point lock screw ). The screw is mainly through the vacuum transmitter generator in the electric screwdriver on the adsorption force, take a single screw, and then run to locate the product hole, electric screwdriver down automatically locked into the product. Sub-feed efficiency with the distance traveled, running speed, generally 1.5-2 / sec.

Air suction automatic screw machine is the air blowing automatic screw machine to add.

Automatic lock screw machine air blowing:

1, air-blown automatic lock screw machine is generally suitable for the head diameter m5 following screws, the length of less than 25mm, while the total length of the screw is greater than the screw head diameter of more than 1.3 times, or in the feed tube will produce a flip phenomenon, which can not be properly sent , Sub-feed efficiency can be achieved 1 / s.

2, air-blown automatic screw machine is automatically sent to the screw machine system (that is, screw feeder) and automatic robot combination, that is, the screw through the compressed air blowing to the bottom of the mouth, electric screwdriver down to automatically lock into the product The Which screw drive path by the robot programming control, pneumatic screw system with the work, plus screw sliding teeth, floating locks, leaks and other testing; complete set of equipment with automatic completion of this mode of automatic screw machine is the biggest advantage of flexibility and stability ,efficient. According to the set coordinates, the machine automatically completes the product lock payment. Z-axis can be installed 2 or 4 electric screwdriver at the same time lock, high production efficiency.

 Compared with the air-suction automatic screw machine, inflatable lock screw machine to the screw directly to the mouth of the mouth, eliminating the time to take the screws back and forth, more efficient and more stable.